Logo

Der Durchbruch
Das Prinzip
Das Abroll-System
Das Zahnrad-System
Das Scheren-System
Das Stampfwerk
Soll ich mich schämen?

Die Software-Ratsche
autonom?
Impulsaustausch
Motus als Getriebe
Motus + Pendel
Motus + Satellit
Das Primum movens

Das Unwuchtsystem
Die Geheimnisse ..
Wenn ein Pfund ..
Das Kreuz
Der Drehpunkt
Das Kreuz im Rad

the momentous 13
my solution
the camshaft
geneva drive

... even more sites
     in 2022


..back to startpage

 

Titelgrafik

  © 2020 by Alois Zimmermann                                                   | Kontakt | Impressum | Updates | Ausblick |   

My solution to be a Bessler-wheel             back to german

With four flying weights the oscillation of the inner unbalanced system remains within a range that a pendulum can manage. So for me, this solution results:

Animation P1213

The construction contains the same 12:13 gear in the center as already shown on page ”The momentous 13”. It is only covered here to highlight two important aspects: offset and oscillation of the unbalanced wheel or unbalanced cross.
The animation shows the principle of energy exchange, but not the release mechanism that initiates the centrifuging of the flying weights. Since the gears of Algodoo simulation fail at the needed weights and speeds, I have laboriously created a GIF animation step by step to make the process understandable. The principle is the same as on the previous page: The inner wheel rolls down a ”tooth” and then swings back to the starting height, only the procedure is slightly different.
On the right side the flying weights become part of the outer wheel and cause acceleration (energy gain). On the left side they become part of the inner cross and need energy to get to the top. Besides the wheel itself also the pendulum (red, according to Besslers MT13 ”in half moon shape”) will work as an energy storage. When the weights jump up, it will be loaded, the unbalanced cross will be pressed down. Afterwards, it lifts the cross when the weights have moved to the outer wheel.

Now I won't list all of Besslers hints fitting to this solution, but I want to add one from page 71 of Besslers Poetic Apology:

  „For if I am already placing here
    Into a creation for example one cross only/
    You'll see it moving quite slowly
    Hardly turn around by itself;
    On the other hand / when I built in
    Lots of crosses/ belts and weights /
    This way the wheel can run much faster/
    will unsettle the calculation of Wagner”

Two further crosses, each offset by 30 degrees, fit in there perfectly. And it becomes more and more obvious that MT13 and MT55 clearly point in this direction.

nächste Seite

   

to the top of the page